Specifications
Input Impedance: INPUT 1M ohms , AUX-IN 100K ohms
Maximum Output Power: 60W RMS
Speaker: 6.5”, 4ohm, 60W, FRFR Loud Speaker
Frequency Response Range: 40Hz ~ 16kHz
Power Supply: DC28V, 4A (Center Negative)
Dimensions: 300mm x 225mm x 326mm
Highlights
Bass Amp Modeling with Cab IRs extend various tone ability.
Support 3rd party IRs(1024 samples) loading with Mighty Bass edit software.
White-box compressor effect offers you analog touch and response.
Independent IR toggle switches for Amp and DI out.
USB audio stream for recording interface with routing setup.
Including NMP-2 to remote Drum & Loop(60 seconds).
Portable and versatile.
50 watts compact modeling bass amp with 6.5" loud speaker
Gate, EFX, Amp Model, IR, Modulation, Reverb
Drum & Loop (60s phrase loop)
Bluetooth Audio Stream
Free APP controller for preset access, management and editing
USB recording interface, firmware update, edit software
Rear panel:
USB PORT: Firmware Update, Edit Software, Recording
DI OUT: You can use DI OUT for balanced signal to interface or PA system.
IR TOGGLE SWITCH: You can engage Cabinet Impulse Response signal by the independent
toggle switches. DI toggle switch is related to DI OUT. AMP toggle switch is related to AMP.
FOOT SWITCH JACK: Connects with NUX NMP-2, you can trigger the TIP(B foot switch) for
LOOP function(60 seconds phrase loop) and trigger the RING(A foot switch) for DRUM function.
Mighty amp mobile app:
Mighty Bass 50BT's Bluetooth can do more than just audio playback. You can also control the
amplifier with the MightyAmp mobile application.
There are loads of Amp Models, Bass Cabinet IRs, and effects available with our FREE MightyAmp APP.
The best part is that you can save all the parameters to each channel for future use